龙岩 当地 软管泵滑模机使用方法

软管泵具有输送强研磨性介质的能力。它无阀、无密封，同介质接触的 部件是橡胶软管的内腔，压缩软管的转子完全独立于介质之外。

The hose pump has the ability to transport strong abrasive media. It has no valve, no seal, and the only part in contact with the medium is the inner cavity of the rubber hose. The rotor of the compression hose is completely independent of the medium.

众所周知软管泵在运行时，是通过一根U型附有弹性的橡胶软管来完成输送。今天小编需要强调的是，软管存放时间不宜过长，一般以一年为限。在停工期间，对装有软管的泵，若长期不用，每隔一个月需转动泵一次。以免压辊长时间压在泵管的某一处，减弱管子回弹性，影响其流量的输送。

It is well known that when the hose pump is running, it is conveyed through a U-shaped rubber hose with elasticity. Today the editor needs to emphasize that the storage time of the hose should not be too long, and it is generally limited to one year. During the shutdown period, if the pump is equipped with a hose, if it is not used for a long time, the pump needs to be rotated every other month. So as not to press the roller for a long time at a certain position of the pump tube, it will weaken the resilience of the tube and affect its flow rate.

 

软管泵的设计选型要求：
1、当工艺条件没有特定的要求时候，那么选泵的流量是可以大于实际的需求流量的。
2、工艺条件在连续生产的时候，那么它本身的实际需要流量要和额定的流量吻合，如果是有特殊的需求，那么可以选择变频调速的泵。
3、软管使用的温度要小于100℃，主要是在工作的过程中会产生热量，如果是周围散热条件比较好的时候，那么介质的温度可以达到一百。
4、主要成分是天然橡胶，因此在选用的时候，要考虑软管对介质的适应性。
5、进出口是在同一个方向的，并且进出口是可以相互之间调换的，可以根据具体的情况来定。